|
DSCN1518
Here's a nice close up. I didn't get any pics of the build as I'm busy enough just trying to get stuff out. If you want a closer look come out to PIR in Portland this Friday and Saturday night. Date and time at nedra.com
Date: 12/31/1969
Owner: Jim Husted
Views: 1579
|
DSCN2003
Here's the motor I built up for the Electric Dragin raffle. It's a medium sized 4 brushed 6.7" motor made from a Crown 36 volt drive motor.
Date: 12/31/1969
Owner: Jim Husted
Views: 1391
|
DSCN2004
I drilled and tapped new holes and set the brush advance by 7.5 degrees for a CCWDE rotation. I removed the old lift style shaft and installed a 7/8"X2" 3/16th" keyed shaft for easy sprocket attachment.
Date: 12/31/1969
Owner: Jim Husted
Views: 1315
|
|
DSCN2005
I had to paint it Dragin green and it's a bit darker than the pics show it as.
Date: 12/31/1969
Owner: Jim Husted
Views: 1326
|
DSCN2006
I swapped the end plates out as the end plates this motor came with weren't as user friendly, and this 4 holed DE plate should make for an easy install
Date: 12/31/1969
Owner: Jim Husted
Views: 1390
|
DSCN2007
Keith's going to get me a finished weight and length as I was just hurrying to get it out in time but it's about 55 lbs and 11ish" long.
Date: 12/31/1969
Owner: Jim Husted
Views: 1356
|
